Build your pipe network

Choose a component and click the drawing area. Draw pipes between two points. Drag nodes to reshape the network.

02 · DEFAULT PIPE

Inside diameter (mm)

Roughness (mm)

Metres per grid cell

Minor loss K (pipe)

Pipe length follows the plan-view scale. Elevation change is set separately on each node; drawing itself is 2D.

03 · FLUID / OPERATING POINT

Fluid

Density (kg/m³)

Dynamic viscosity (mPa·s)

Flow (L/min)

Inlet pressure (bar g)

04 · MATERIAL & PIPE SIZING

Pipe material / roughness preset

Suggested inside diameter

Target velocity (m/s)

Presets are indicative hydraulic inside diameters, not certified nominal pipe size or schedule dimensions.

05 · DESIGN CHECKS & SWEEP

Velocity alert threshold (m/s)

Minimum outlet pressure (bar g)

Run a serial-path analysis to enable comparison.

06 · DEMO TEMPLATES

Network canvasSelect Pipe, then click the start and end points

Wheel to zoom · Drag empty space to pan · Drag node to move · Click a component to edit · Esc cancels

Connected pipe length—

Pressure loss—

Estimated outlet pressure—

Maximum velocity—

Ready. Select Pipe to connect components, or load an example network.

Edit component